Welcome to ManualsDock! Read Millions of manuals for free.

Frigidaire FPET3077RF Electric Wall Oven Installation Instructions Manual

Frigidaire FPET3077RF Electric Wall Oven FEATURE

Frigidaire LOGO

Frigidaire FPET3077RF Electric Wall Oven

Frigidaire FPET3077RF Electric Wall Oven PRODUCT

About Frigidaire
Frigidaire is a brand of home appliances that is owned by the Electrolux Group. It was founded in the United States in 1918 and is now a global brand, offering a wide range of products including refrigerators, freezers, air conditioners, dishwashers, ranges, cooktops, wall ovens, washers and dryers, and more.

Frigidaire is known for its commitment to quality, innovation, and design, and offers products in a range of styles and price points to meet the needs of different consumers. If you’re in the market for a new home appliance, Frigidaire is a reputable brand that offers a wide selection of high-quality products that can help make your home more comfortable and convenient.

Full terms of the Warranty covering your Frigidaire Dishwasher are detailed on the back page of this booklet. Please read them.
The model and serial numbers for your dishwasher are found in the door opening, on the lower right flange of the tub. Record and retain these numbers.

DIMENSIONS

Single Wall Ovens

WARNING
Do not remove spacers (if equipped) on the side walls of the built-in oven. These spacers center the oven in the space provided. The oven must be centered to prevent excess heat buildup that may result in heat damage or fire.

NOTES:

  1. Base must be capable of supporting 150 pounds (68 kg) for 27″ models and 200 pounds (90 kg) for 30″ models.
  2. Allow at least 21″ (53.3 cm) clearance in front of the oven for door depth when it is open.
  3. Dimension G (cutout depth) is critical to the proper installation of the built-in oven. If the oven decorative trim does not butt against the cabinet, or if noise is heard on convection models, verify dimension G to assure it is the required depth.
  4. For a cutout height greater than 28 1 / 4 ” (71.8 cm) add one 2″(5 cm) wide wood shim of appropriate height to each side of the opening under the appliance side rails.
  5. For a cutout height (H) greater than 281/4″ (71.8 cm) you can order a larger bottom trim through a Service Center.

Frigidaire FPET3077RF Electric Wall Oven FIG-1

PRODUCT DIMENSIONS
MODEL A B C D
27″ (68.6 cm) Wall Oven 27 (68.6) 29 (73.7) 24 5 / 8 (62.5) 24 3 / 4 (62.9)
30″ (76.2 cm) Wall Oven 30 (76.2) 29 (73.7) 28 1 / 4 (71.8) 24 3 / 4 (62.9)
CUTOUT DIMENSIONS AND CABINET WIDTH
F G (Min.) H. Standard Height
(**Others, see notes 4 & 5)
I
MODEL Min. Max. Min. Max .
27″ (68.6 cm) Wall Oven 24 7 / 8 (63.2) 25¼ (64.1) 23 1 / 2 (59.7) 27¼ (69.2) 28 1 / 4 (71.8) 27 1 / 8 (68.9) Min
30″ (76.2 cm) Wall Oven 28 1 / 2 (72.4) 29 (73.7) 23 1 / 2 (59.7) 27¼ (69.2) 28 1 / 4 (71.8) 30 1 / 8 (76.5) Min

All dimensions are in inches (cm). Electrical Requirements

DOUBLE OVENS

WARNING
Do not remove spacers (if equipped) on the side walls of the built-in oven. These spacers center the oven in the space provided. The oven must be centered to prevent excess heat buildup that may result in heat damage or fire.

NOTES:

  1. Base must be capable of supporting 300 pounds (136 kg) for 27″ models and 375 pounds (170 kg) for 30″ models.
  2. Allow at least 21″ (53.3 cm) clearance in front of the oven for door depth when it is open.
  3. Dimension G (cutout depth) is critical to the proper installation of the built-in oven. If the oven decorative trim does not butt against the cabinet, or if noise is heard on convection models, verify dimension G to assure it is according to the required dimension.
  4. For a cutout height greater than 49 5 / 8 ” (126 cm) add a 2″ (5 cm) wide wood shim of appropriate height to each side of the opening under the appliance side rails.
  5. For a cutout height (H) greater than 49 5 / 8 ” (126 cm) you can order a larger bottom trim through a Service Center.

 

Frigidaire FPET3077RF Electric Wall Oven FIG-2

PRODUCT DIMENSIONS
MODEL A B C D
27″ (68.6 cm) Wall Oven 27 (68.6) 50 7 / 16 (128.1) 24 5 / 8 (62.5) 24 3 / 4 (62.9)
30″ (76.2 cm) Wall Oven 30 (76.2) 50 7 / 16 (128.1) 28 1 / 4 (71.8) 24 3 / 4 (62.9)
CUTOUT DIMENSIONS AND CABINET WIDTH
F G (Min.) H. Standard Height
(**Others, see notes 4 & 5)
I
MODEL Min. Max. Min. Max .
27″ (68.6 cm) Wall Oven 24 7 / 8 (63.2) 25 1 / 4 (64.1) 23 1 / 2 (59.7) 48 7 / 8 (124.1) 49 5 / 8 (126) 27 1 / 8 (68.9) Min
30″ (76.2 cm) Wall Oven 28 1 / 2 (72.4) 29 (73.7) 23 1 / 2 (59.7) 48 7 / 8 (124.1) 49 5 / 8 (126) 30 1 / 8 (76.5) Min

All dimensions are in inches (cm).

Electrical Requirements

This home appliance must be supplied with the proper voltage and frequency, and connected to an individual, properly grounded branch circuit, protected by a circuit breaker or fuse. To know the circuit breaker or fuse required by your model, see the serial plate to find the wattage consumption and refer to table A to get the circuit breaker or fuse amperage

Appliance
Rating Watts
240V
Protection
Circuit
Recommended
Appliance
Rating Watts
208V
Protection
Circuit
Recommended
Less than
4800W
20A Less than
4100W
20A
4801W – 7200W 30A 4101W – 6200W 30A
7201W – 9600W 40A or 50A 6201W – 8300W 40A or 50A
9601W and + 50A 8301W and + 50A

Observe all governing codes and local ordinances

  1. A 3-wire or 4-wire single phase 120/240 or 120/208 Volt, 60 Hz AC-only electrical supply is required on a separate circuit fused on both sides of the line (red and black wires). A time-delay fuse or circuit breaker is recommended. DO NOT fuse neutral (white wire). Only certain cooktop models may be installed over certain built-in electric oven models. Approved cooktops and built-in ovens are listed by the MFG ID number (see the insert sheet included in the literature package).
    NOTE: Wire sizes and connections must conform with the fuse size and rating of the appliance in accordance with the American National Electrical Code ANSI/NFPA No. 70-latest edition, or with Canadian CSA Standard C22.1, Canadian Electrical Code, Part 1, and local codes and ordinances.
    WARNING
    An extension cord should not be used with this home appliance. Such use may result in a fire, electrical shock, or another personal injury. If you need a longer power cord you can purchase a 10′ (3 m) power cord kit #903056-9010 by calling the Service Center.
  2. These home appliances should be connected to the fused disconnect (or circuit breaker) box through flexible armored or nonmetallic sheathed cable. The flexible armored cable extending from the appliance should be connected directly to the junction box. The junction box should be located as shown in Figure 1 or Figure 2 and with as much slack as possible remaining in the cable between the box and the appliance, so it can be moved if servicing is ever necessary.
  3. A suitable strain relief must be provided to attach the flexible armored cable to the junction box

WARNING Electrical Shock Hazard

  • Electrical ground is required on this home appliance.
  • Do not connect to the electrical supply until the appliance is permanently grounded.
  • Disconnect power to the junction box before making the electrical connection.
  • This home appliance must be connected to a grounded, metallic, permanent wiring system, or a grounding connector should be connected to the grounding terminal or wire lead on the appliance.
  • Do not use a gas supply line for grounding the appliance.

Failure to do any of the above could result in a fire, personal injury, or electrical shock.

CAUTION
In cold weather shipping and storage conditions, make sure that the oven is in the final location at least three (3) hours before switching on the power. Switching on power while the oven is still cold may damage the oven controls.

Electrical connection

It is the responsibility and obligation of the consumer to contact a qualified installer to assure that the electrical installation is adequate and is in conformance with the National Electrical Code ANSI/NFPA No. 70-latest edition, or with CSA Standard C22.1, Canadian Electrical Code, Part 1, and local codes and ordinances.

Risk of electrical shock (Failure to heed this warning may result in electrocution or another serious injury.) This home appliance is equipped with copper lead wire. If the connection is made to aluminum house wiring, use only connectors that are approved for joining copper and aluminum wire in accordance with the National Electrical Code and local codes and ordinances.

When installing connectors having screws that bear directly on the steel and/or aluminum flexible conduit, do not tighten screws sufficiently to damage the flexible conduit. Do not overbend or excessively distort flexible conduit to avoid separation of convolutions en exposure of internal wires. DO NOT ground to a gas supply pipe. DO NOT connect to the electrical power supply until the appliance is permanently grounded. Connect the ground wire before turning on the power.

WARNING
(If your appliance is equipped with a white neutral conductor.)

This home appliance is manufactured with a white neutral power supply and a frame-connected copper wire. The frame is grounded by the connection of grounding lead to neutral lead at the termination of the conduit, if used in the USA, in a new branch circuit installation (1996 NEC), mobile home, or recreational vehicles, where local codes do not permit grounding through the neutral (white) wire or in Canada, disconnect the white and green lead from each other and use ground lead to the ground unit in accordance with local codes, connect a neutral lead to branch circuit-neutral conductor in usual manner see Figure 4. If your appliance is to be connected to a 3-wire grounded junction box (US only), where local code permits connecting the appliance-grounding conductor to the neutral (white) see Figure 3

NOTE TO ELECTRICIAN: The armored cable leads supplied with the appliance are UL-recognized for connection to larger gauge household wiring. The insulation of the leads is rated at temperatures much higher than the temperature rating of household wiring. The current carrying capacity of the conductor is governed by the temperature rating of the insulation around the wire, rather than the wire gauge alone.

Where local codes permit connecting the appliance grounding conductor to the neutral (white) wire (US Only) (see figure 3):

Frigidaire FPET3077RF Electric Wall Oven FIG-3

  1. Disconnect the power supply.
  2. In the junction box: connect the appliance and power supply cable wires as shown in Figure 3.

If the oven is used in a new branch circuit installation (1996 NEC), mobile home, recreational vehicle, or where local codes DO NOT permit grounding through the neutral (white) wire, the appliance frame MUST NOT be connected to the neutral wire of the 4-wire electrical system. (see figure 4):

Frigidaire FPET3077RF Electric Wall Oven FIG-4

  1. Disconnect the power supply.
  2. Separate the green (or bare copper) and white appliance cable wires.
  3. In the junction box: connect the appliance and power supply cable wires as shown in Figure 4

Model and Serial Number Location

The serial plate is located along the interior side trim of the oven and is visible when the door is opened. When ordering parts for or making inquiries about your oven, always be sure to include the model and serial numbers and a lot number or letter from the serial plate on your oven

Frigidaire FPET3077RF Electric Wall Oven FIG-5

FAQs Frigidaire FPET3077RF Electric Wall Oven

Is it safe to install the Frigidaire FPET3077RF electric wall oven myself?

It is recommended that you hire a licensed electrician to install the Frigidaire FPET3077RF electric wall oven. This is because the installation process requires knowledge of electrical wiring and proper installation procedures.

How much space do I need for the Frigidaire FPET3077RF electric wall oven?

The Frigidaire FPET3077RF electric wall oven requires a cutout of 28-1/2″ wide x 27-1/4″ deep x 28-1/4″ high.

What type of electrical wiring is required for the Frigidaire electric wall oven?

The Frigidaire electric wall oven requires a 240V electrical circuit with a minimum of a 40-amp circuit breaker.

Can the Frigidaire FPET3077RF electric wall oven be installed under a cooktop?

No, the Frigidaire electric wall oven is designed for installation in a wall cabinet.

Does the Frigidaire FPET3077RF electric wall oven require venting?

No, the Frigidaire electric wall oven is a ventless oven and does not require any venting.

How do I level the electric wall oven?

The Frigidaire electric wall oven comes with leveling legs that can be adjusted to level the oven.

Can the Frigidaire electric wall oven be installed in a mobile home?

Yes, the Frigidaire electric wall oven can be installed in a mobile home as long as it meets the installation requirements and local codes. It is recommended that you consult with a licensed electrician for installation in a mobile home.

How long does the installation process take?

The installation process for the Frigidaire FPET3077RF electric wall oven can take several hours, depending on the complexity of the installation and the existing wiring and electrical setup in your home. It is recommended that you schedule a professional installation to ensure that the installation is done correctly and safely.

For more manuals by Frigidaire, visit ManualsDock

 

Leave a Comment