Tyger Auto T3 Tonneau Cover User Manual

Tyger Auto T3 Tonneau Cover

Please make sure all parts are included in the package

STEP 1

Clean the truck bed thoroughly before installation. Place the assembled cover on the truck bed against the bulkhead; make sure the cover is even on all sides, then un-buckle the safety straps.

STEP 2

Securing Front Clamps
Please refer to supplemental instructions for utility track bracket installation for Toyota and Nissan models.

1. Pull down the front clamps into a vertical position. The horizontal position has been set for optimal tment, it still can be adjusted if necessary, please refer to the Adjusting Clamp Position section.
2. Hook jaw portion of the clamp under the metal bed rail lip. A clamp pad can be inserted at the contact point to protect the paint.
3. Turn the knob until the side Q-seal of the cover is compressed and the clamp is snug.

IMPORTANT
The clamp must make solid contact with the metal bed rail lip for the cover to be secure.

STEP 3

Securing Safety Clamps
Turn the knob counterclockwise to loosen the clamp with the yellow strap, attach the clamp to the metal bed rail lip on both sides, then tighten. Must make sure safety clamps are in direct contact with the metal part of the bed rail lips.

STEP 4

Securing Rear Clamps and Cover
Unfold the cover to the tailgate; make sure it’s even on both sides.

1. Pull down the rear clamps. The horizontal position has been set for optimal fitment, it still can be adjusted if necessary, please refer to the Adjusting Clamp Position section.
2. Hook clamps under the metal bed rail lips. A clamp pad can be inserted at the contact point to protect the paint.
3. Push the clamp handle down to the vertical position to secure the rear latch; make sure the side Q-seal of the cover is compressed and the clamps are snug.

IMPORTANT
The clamp must make solid contact with the metal bed rail lip for the cover to be secure.

After the rear clamps have been latched securely, close/lock the tailgate, and the cover cannot be opened from the outside.

NOTE
Cover may not completely cover the outside edge of the bed rails due to slight differences in truck bed shape for different year models.

Folding Up the Cover

Open the tailgate and release the rear latches. Fold up the cover once, and secure the rear latches into the grooves on both sides as shown in Fig.1 to avoid the rear latch handle hanging freely (Fig.2) and damaging the vinyl when the cover is folded again. When the cover is folded at the cab, ensure the safety buckles are properly secured on both sides.

Adjusting Clamp Position

The factory position has been set for optimal tment, but if necessary, the horizontal clamp position can be adjusted by releasing the top Phillips Screw and relocating the clamp to 1 of the 3 available positions.

SAFETY NOTES

• Check and secure all clamps before driving.
• Do not drive with cover folded open and safety straps un-buckled.
• Do not overload cargo or place sharp objects in contact with the cover.
• Safety clamps provide additional security, but they do not replace front clamps. Front clamps must be securely attached.
• The maximum weight capacity of the cover is 30 lbs, weight must be evenly distributed.
• If the truck is equipped with an Over-the-Bedrail bed liner (Fig. 3) or bedside rail cap with a plastic lip lower than the factory metal bed lip (Fig. 4), small holes of about 2” x 4” will need to be cut on the plastic liners so the clamps can be fastened securely to the metal part of the truck bed lips (Fig. 5).

TROUBLESHOOTING

WARRANTY

TYGER provides hassle hassle-free warranty against any manufacturing defects.

• To claim a warranty, please visit our website www.tygerauto.com/contact

For more Manuals by Tyge, visit ManualsDock

FAQS About Tyger Auto T3 Tonneau Cover