RadioShack 2733350 Cell Phone Stand With Wireless Charger User Manual

RadioShack 2733350 Cell Phone Stand With Wireless Charger

INSTRUCTIONS FOR USE

1. Plug the power adapter into the socket. One section of the USB power cable is connected to the adapter and the other is connected to the wireless charger
2. Place the mobile device that supports wireless charging in the charging area of wireless charging
3. Remove the mobile device after fully charged

Note
This product supports 15W fast charging function. For a better experience, please use QC3.0 and above

INDICATOR DESCRIPTION

• Power ON: The red and blue light flashes 1 time, and then goes off to enter the stand-by state.
• Charging: Steady red warning light
• Foreign object detection: flashes continuously until the product is removed, and the flashing is canceled

PRECAUTIONS

1. Do not squeeze or hit the object with force
2. Do not disassemble or modify by yourself
3. Do not use it near hot or hot objects, and do not use it in high temperature, humid, oily environment
4. Do not place it too close to magnetic cards (ID cards, bank, cards, etc) with magnetic strips or chips to avoid magnetic failure
5. Do not place metal or metal phone cases on the wireless charger
6. Please keep the distance between the implanted medical device (new pacemaker, implantable cochlea, etc.) and the wireless charger at least 20cm to avoid potential interference with the medical device
7. Do not shred or pierce this product with metal, do not burn or discard it in water
8. Do not short-circuit this product
9. Unplug the power supply when not using the product, and store it in a dry and ventilated place

PRODUCT PARAMETERS

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note
This equipment has been tested and found to comply with the limits for a class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. if this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirements, This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body.

For more Manuals by RADIOSHACK, visit MANUALSDOCK