BUNN CSB2G Speed Brew Elite Coffee Maker Owner Manual

BUNN CSB2G Speed Brew Elite Coffee Maker

SPECIFICATIONS

• BREW CAPACITY: 4 to 10 (5) oz. cups per batch
• ELECTRICAL: UL and C-UL Listed FOR HOUSEHOLD USE ONLY. The coffee maker has an attached, 3-prong grounded cord set and requires 2-wire service with the ground.

ELECTRICAL RATED

• GRX: 120 volts AC, 7.5 amps, single phase, 60 Hz, 900-watts
• BX: 120 volts AC, 7.5 amps, single phase, 60 Hz, 900-watts
• SBS: 120 volts AC, 7.5 amps, single phase, 60 Hz, 900-watts
• CSB1: 120 volts AC, 7.5 amps, single phase, 60 Hz, 900-watts
• CSB2: 120 volts AC, 7.5 amps, single phase, 60 Hz, 900-watts
• BTX: 120 volts AC, 7 amps, single phase, 60 Hz, 850-watts
• CSB3T: 120 volts AC, 7 amps, single phase, 60 Hz, 850-watts

COFFEE MAKER FEATURES

1. Brew Funnel
2. Lid
3. Internal Hot Water Tank
4. Drip-Free Glass Carafe
5. Carafe Lid
6. Warmer Plate
7. Sprayhead
8. Warmer Switch
9. Tank Power Switch
10. Pour-In Bowl
11. Thermal Carafe
12. Thermal Carafe Lid
13. Base
14. Top Cover

SAFEGUARDING

IMPORTANT
Follow basic safety precautions when using electrical appliances to reduce the risk of fire, electric shock, and personal injury.

• READ ALL THE INSTRUCTIONS IN THIS MANUAL.
• Use caution. This coffee maker produces hot liquids: hot liquids can burn you
• Place and use the coffee maker on a level surface.
• Do not touch hot surfaces. Use handles.
• Do not tip the coffee maker.
• To protect against electric shock, do not place cords, plugs, or coffee maker in water or other liquids.
• Do not open the lid during brewing.
• Close supervision is necessary when a coffee maker is used around children.
• The internal hot water tank contains hot water. Before cleaning, removing, or replacing parts, press the power switch off, unplug the coffee maker, and let it cool (up to 2 hours.)
• Do not operate the coffee maker with a damaged cord or plug, or any other malfunction or damage. Return the appliance to an authorized service facility for examination, repair, or adjustment.
• Using an accessory not evaluated for use with this coffee maker may cause injury.
• Use a coffee maker indoors only.
• Do not let the cord hang over the edge of the table or counter.
• Do not place the coffee maker in or near a hot gas or electric burner, in a heated oven, or any other heated area.
• Do not use a carafe on a range top or in a microwave.
• Do not use the coffee maker for any purpose other than its intended use.
• Do not remove the brew funnel or carafe while brewing.
• Do not set a hot carafe on a cold surface.
• Do not use a cracked carafe or a carafe with a loose or weakened handle.
• Do not pour any liquid into the internal hot water tank other than water or vinegar for cleaning, as specified in this manual.
• Do not clean the carafe with cleansers, steel wool pads, or other abrasive materials.
• When the coffee maker is not in use, keep the lid in the closed position.
• To disconnect, turn any control to the OFF position, then unplug from the wall outlet.

INITIAL SETUP

• Slide empty brew funnel into funnel rails.
• Fill the carafe with water. Pour Water into the coffee maker.
  NOTE
  Keep the lid open.
• Place the carafe under the funnel. Close lid. Wait 4 minutes while the internal tank fills.

• Repeat steps 2 and 3, until water flows from the funnel.
• Plug in the coffee maker.
• Press the power switch located on the side. (I=ON, O=OFF) Wait 15 minutes for water in the tank to heat.

HOW TO BREW

1. Place a BUNN® coffee filter into the brew funnel
2. Scoop ground coffee into the filter
3. Gently shake the brew funnel to level the grounds
4. Slide the funnel into the funnel rails
5. Fill the carafe with water: 20oz for 4 cups, 50oz for 10 cups.
6. Open the lid, and pour water into the coffee maker
7. Position the carafe on the warmer plate (or on the base for Thermal models*)
8. Close the lid**
9. Turn on the warmer switch
10. Wait 4 minutes for the drip-out to complete

BREWING CHART

BASIC CLEANING

FOR SPEED BREW MODELS: (Excluding Thermal models)

• Wash the brew funnel and glass carafe after each use.
• Both are top-rack dishwasher safe.
• Wipe the outside of the coffee maker occasionally, including the area above the brew funnel.

FOR THERMAL MODELS

Important
Do not use an abrasive device to clean the carafe, because it will scratch the stainless steel. Occasionally, remove the brew-through valve on the Thermal Carafe lid and clean with mild, nnonabrasivedetergent. To remove the valve, lift it at the edge and pull it p. Be sure to clean the passage where the valve is located (the valve is not on all models).

• To remove coffee stains from inside the thermal carafe, place a paper filter in the brew funnel and pour 2 teaspoons of powder dishwasher detergent into the brew funnel.
• Pour one carafe of water into the coffee maker.
• Place the carafe under the funnel and close the lid.
• When the brewing cycle stops, remove the brew funnel and discard the filter.
• Rinse the funnel.
• Allow the carafe to sit for about 15 minutes.
• Use a soft-bristled brush to clean the inside and outer rim of the carafe.
• Scrub the carafe and pour the lip and lid with a soft cloth, warm water, and mild detergent.
• When finished, pour out the solution in the carafe.
• Rinse the carafe and the lid.

CLEANING THE SPRAY HEAD

Cleaning the sprayhead tube removes deposits formed by natural mineral content in your water. The more mineral content in your water, the more you should clean. A good rule of thumb is to clean it every 3 months. If you have very hard water, then twice a month may be necessary. You will need a toothpick, dish soap, and a soft cloth.

• Press the tank power switch to the OFF position, unplug the coffee maker, and allow it to cool for at least 2 hours.
• Remove the funnel and unscrew the spray head, loosening it with your fingertips.
• Reinsert funnel in machine.
• Pour a carafe of fresh water into the coffee maker. Keep the lid open.
• Place the empty carafe under the funnel and close the lid. Water will flow into the carafe.
• Check the spray head holes and clear any deposits with the toothpick.
• Clean the spray head with a cloth and dish soap. Rinse with water.
• Empty the water from the carafe and replace the empty carafe under the funnel.
• Remove the brew funnel and reinstall the spray head. Reinsert the brew funnel.
• Plug in the coffee maker. Press the tank power switch to the ON position.
• Wait 15 minutes for the water in the tank to reach brew temperature.
• Your machine is again ready for brewing

ROUTINE CLEANING

Routine cleaning of your coffee maker removes mineral deposits in the internal hot water tank and will prolong the life of your coffee maker. You will need 1 quart (32oz) of white vinegar, a toothpick, and dish soap.

• Slide the brew funnel into the funnel rails.
• Place the carafe under the funnel.
• Open the lid and pour the vinegar into the coffee maker.
• Close the lid. Empty the carafe when the liquid stops flowing.
• Flip the tank switch to the OFF position and unplug the coffee maker. Allow the vinegar to sit in the coffee maker for at least 2 hours. Remove the brew funnel and unscrew the spray head. Check the spray head holes and clear any deposits with the toothpick.
• Clean the spray head with a cloth and dish soap.
• Rinse with water.
• Pour a carafe of fresh water into the coffee maker. Place the carafe under the funnel and reinsert the funnel.
• Close the lid (the water will begin to flush out the vinegar from the internal hot water tank).
• Empty the carafe when the liquid stops flowing.
• Repeat the process of cycling fresh cold water 3 or more times, or until you no longer smell vinegar.
• Remove the funnel and reattach the spray head.
• Replace the funnel and place the carafe under the funnel. Plug in the coffee maker. Flip the tank switch to the ON position.
• Allow the water in the tank to reach brewing temperature (which should take about 15 minutes). Your coffee maker is again ready for brewing.

DRAINING THE COFFEE MAKER

WATER IN THE COFFEE MAKER SHOULD BE DRAINED WHEN THE COFFEE MAKER IS

• Transported
• Shipped
• Stored in an unheated location with a chance of freezing
• Not to be used for an extended period

TO DRAIN

1. Flip the tank switch to the OFF position, unplug the coffee maker, and allow it to cool for at least 2 hours.
2. Remove the funnel and the spray head, loosening with your fingertips.
3. Grasp the back of the coffee maker and turn it upside down over a sink.
4. Continue tipping the coffee maker until the flow from the spray head tube and lid stops.
5. Attach the spray head and insert the funnel into the coffee maker.
6. Return the coffee maker to the upright position.

TROUBLESHOOTING

WARRANTY

Bunn-O-Matic Corporation (“BUNN”) warrants the BUNN® Speed Brew Coffee maker, except glass carafe, to be free from defects in materials and workmanship existing at the time of manufacture and appearing within the later of the following warranty periods:

• Three (3) years from the date of original purchase of a NEW Coffee maker with delivery of a valid receipt evidencing such purchase or, in the absence of such a receipt, from the date of manufacture; or
• One (1) year from the date a REPAIRED OR REPLACEMENT Coffee maker is received by the customer, in the case determined a coffee maker returned within the NEW Coffee maker warranty period required repair or replacement.

If such a defect appears during the warranty period, we will (at our sole option) repair or replace the defective Coffee maker with no charge for service or parts, provided the Coffee maker is delivered at the customer’s expense to one of our authorized service centers (see page 4 for customer service info). Warranty does not cover claims resulting from misuse, failure to follow instructions on installation and use, use with water having a high mineral content, neglect, use of unauthorized attachments, commercial use, use on a current or voltage other than specified on the Coffee maker, or unauthorized service during the warranty period on conditions otherwise covered by warranty.

THIS WARRANTY SHALL BE EXCLUSIVE AND SHALL BE INSTEAD OF ANY OTHER WARRANTY, WRITTEN, ORAL, OR IMPLIED INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

In any event, the duration of any warranties implied by law, including but not limited to any implied warranties of merchantability or fitness for a particular purpose, is expressly limited to the duration of this limited warranty. Some states do not allow time limitations on implied warranties, so the above limitation may not apply to you.

THE CUSTOMER’S EXCLUSIVE REMEDY FOR BREACH OF THIS WARRANTY OR OF ANY IMPLIED WARRANTY, OR ANY OTHER OBLIGATION ARISING BY OPERATION OF LAW OR OTHERWISE, SHALL BE LIMITED AS SPECIFIED HEREIN TO REPAIR OR REPLACEMENT, AT OUR SOLE OPTION. IN ANY EVENT, RESPONSIBILITY FOR SPECIAL, INCIDENTAL, AND CONSEQUENTIAL DAMAGES IS EXPRESSLY EXCLUDED.

Some states do not allow limitation or exclusion of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights; you may have other rights, which vary from state to state.

TRADEMARKS
BUNN Pour-O-Matic, BUNN, BUNN with the stylized red line, The Horizontal Red Line, Bunn-OMatic, Bunn-O-Matic, Velocity Brew, My Café, Speed Brew, Phase Brew, trifecta, Air Infusion, Quality Beverage Equipment Worldwide, The Mark of Quality in Beverage Equipment Worldwide, A Partner You Can Count On, Brew Better Not Bitter, Brew better, not bitter., Coffee At Its Best, Nothing Brews Like a BUNN, Respect Earth, Respect Earth with the stylized leaf, and coffee cherry design, are either trademarks or registered trademarks of Bunn-O-Matic Corporation.

For more Manuals by BUNN, visit MANUALSDOCK

Faqs About BUNN CSB2G Speed Brew Elite Coffee Maker