BUNN Heat N Brew Programmable Coffee Maker Owner Manual

BUNN Heat N Brew Programmable Coffee Maker

specifications

electrical:
UL and C-UL are Listed for Household Use Only. This brewer has an attached, 3-prong grounded cord set and requires 2-wire service with ground, rated 120 volts AC, 11 amps, single phase, 60Hz, 1300 watts.
brew capacity:
4 – 10 cups per batch (20 – 50oz).

Not designed for High Altitude locations above 4,000 feet. High Altitude units are available. See Bunn.com for details.

GET TO KNOW YOUR BREWER

NOTE:
The carafe lid is packed separately from the brewer and carafe.

IMPORTANT SAFEGUARDS

Follow basic safety precautions when using electrical appliances to reduce the risk of fire, electric shock, and/or personal injury:

• READ ALL INSTRUCTIONS.
• Do not touch hot surfaces. Use handles.
• To protect from electric shock, do not place cords, plugs, or brewer in water or other liquids.
• Do not open the lid during heating or brewing.
• Close supervision is necessary when the brewer is used by or around children.
• Unplug from the outlet when not in use and before cleaning. Let the brewer cool before removing or replacing parts, and before cleaning.
• Do not operate the brewer with a damaged cord or plug or if the brewer malfunctions or is damaged in any way. Contact Customer Support (see page 7)
• Using an accessory not evaluated for use with this brewer may cause injury.
• Do not use outdoors.
• Do not let the cord hang over the edge of the table or counter or touch hot surfaces.
• Do not place the brewer on or near a hot gas or electric burner or in a heated oven.
• Do not use the brewer for any purpose other than its intended use.
• Do not remove the brew funnel or carafe while brewing.
• The carafe is designed for use with this appliance. Do not use a carafe on a range top or in a microwave.
• Do not set a hot carafe on a wet or cold surface.
• Do not use a cracked carafe or a carafe with a loose or weakened handle.
• Do not pour any liquid into the water tank other than water or vinegar for cleaning, as specified in this manual.
• Do not clean the carafe with cleansers, steel wool pads, or other abrasive materials.
• When the brewer is not in use, keep the lid in the closed position.

NOTE:
Heating water to the ideal brewing temperatures naturally generates some steam. BUNN suggests using your Brewer in an open area, and never under cabinets that may be damaged over time by exposure to steam.

NOTE:
The short power-supply cord supplied reduces the risk of becoming entangled in or tripping over a longer cord. Extension cords are available and may be used if care is exercised in their use. If an extension cord is used, its marked electrical rating must be at least as great as the electrical rating of the brewer.

The longer cord should be arranged so it will not hang over the edge of a table or counter and that it cannot be pulled on by children or tripped over. The extension cord must be a 3-wire cord of the 3-prong, 3-socketed, grounding type (including grounding conductor).

Record the Model and Date code before using:
The model is located on the lower back of your brewer. The date code is located on the metal prongs of your power cord – 4 digits are etched on each side of the metal prongs (Ex. 9999 99CH).

PROGRAMMING YOUR COFFEEMAKER

NOTE:
You must set the clock to use the Auto-Start function. Remember to reset the clock for time changes and power outages.

set clock

1. Plug the power cord into a standard electrical outlet.
2. The display will flash for 10 seconds before setting it automatically. (If not set, midnight becomes the default time.)
3. Set time using the H (hour) and M (minute) buttons.
4. Numbers scroll forward only.
5. Take care to select the correct AM/PM time.
6. Press the Clock button again to set time

NOTE:
The Auto-Start function must be activated each time you want to schedule a brew. If the Auto-Start button is not illuminated, the Auto-Start function is not activated.

auto-start (optional)

1. Press the Auto-Start button. H (hour) and M (minute) buttons will light up, time will flash on digital display.
2. Set time using the H (hour) and M (minute) buttons. Numbers scroll forward only. Stop at the desired AutoStart time. Take care to select the correct AM/PM time.
3. When the desired time is on the digital display, press the Auto Start button to activate. It will be set and AutoStart will activate or wait 10 seconds and it will set automatically. Once activated, the Auto-Start button will illuminate white.
4. Place the BUNN coffee filter and coffee grounds into the Brew Funnel and slide into the Funnel Guides.
5. Fill the coffeemaker with the desired amount of water and place the Carafe on the base of the coffeemaker (failure to follow steps 4 and 5 may result in property damage).

NOTE:
To check your Auto-Start setting at idle, press the Auto-Start button twice and the digital display will flash the programmed time. The flashing time will remain the set time unless you change it. After 10 seconds with no buttons pushed, the Auto-Start button will illuminate and Auto-Start is set. To cancel, press Auto Start again.

Water Coffee

• 4 Cups/20 oz 32.5 grams ~4-5 tbsp
• 6 Cups/30 oz 48.7 grams ~6-7 tbsp
• 8 Cups/40 oz 64.9 grams ~8-9 tbsp
• 10 Cups/50 oz 81.3 grams ~10-11 tbsp

CARE & CLEANING

Wash the brew funnel and glass carafe after each use – both are top-rack dishwasher safe. Occasionally wipe the outside of your coffeemaker, including the area above the funnel, with a mild, non-citrus detergent and a damp cloth. While cleaning your coffeemaker, check the glass carafe handle and tighten it with a Phillips screwdriver if it’s loose.

This unique brewing system is sensitive to mineral build-up from the water you use.
Therefore, it is very important to clean the internal system at least every 3 months or whenever the digital displays show “CLEAN” after a brew cycle is done. The higher the mineral content in the water you use, the more often you should clean. Regular internal system cleaning will prolong the life of your coffeemaker and help guarantee an optimal brew result.

Bunn accessories
BUNN offers a complete line of accessories including paper filters, glass carafes, thermal carafes, replacement funnels, and more. Visit www.bunn.com to order parts and accessories, or call the BUNN Home Products Team at 1-800-352-2866.

1. Remove the Sprayhead located above the Brew Funnel by turning with your fingertips.
2. Check the Sprayhead. If plugged with mineral deposits or white flakes, use a toothpick to remove them. Clean the Sprayhead with a cloth and mild detergent. Rinse the Sprayhead with water.
3. Slide the empty Brew Funnel into the Funnel Guides under the Sprayhead.
4. Open the Flip Lid on top of the coffeemaker and fill the coffeemaker with equal parts of water and white vinegar solution (25 oz each).
5. Close the Flip Lid.
6. Place the empty Carafe on the base Warmer Plate of the coffeemaker.
7. Let the solution set for a few minutes.
8. Press the Brew button to cycle the vinegar solution through the coffeemaker.
9. Empty the carafe at the end of the cycle.
10. Run 3 or more additional cycles with full carafes of water to flush the remaining vinegar solution from the coffeemaker.
11. Reinstall Sprayhead.
12. To reset the “CLEAN” indicator, press and hold the “H” and “M”  buttons for 5 seconds.

Note:
For a stronger clean, 100% white vinegar (50oz) can be used. Press the Brew button and let the machine heat for 4 minutes. Then press the Brew button to pause the machine. Let the vinegar soak for 30 minutes. Press the Brew button to restart the machine and finish the brew cycle. Run 3 or more cycles with full carafes of water to flush the remaining vinegar from the coffeemaker.

TROUBLESHOOTING

NOTE:
Our friendly Customer Service Group is ready to help at 1-800-352-2866 or online at www.bunn.com

FOR MORE MANUALS BY BUNN, VISIT MANUALSDOCK