Welcome to ManualsDock! Read Millions of manuals for free.

Get 20% off and boost your website's speed with Hostinger Cloud Hosting!

BUNN 55200 CSB3T Speed Brew Coffee Maker Owner Manual

BUNN FEATURED

BUNN logo

BUNN 55200 CSB3T Speed Brew Coffee Maker

BUNN 55200 CSB3T Speed Brew Coffee Maker

SPECIFICATIONS

  • BREW CAPACITY: 4 to 10 (5) oz. cups per batch
  • ELECTRICAL: UL and C-UL Listed FOR HOUSEHOLD USE ONLY. The coffee maker has an attached, 3-prong grounded cord set and requires 2-wire service with the ground.
  • ELECTRICAL RATED:
  • GRX: 120 volts AC, 7.5 amps, single phase, 60 Hz, 900-watts
  • BX: 120 volts AC, 7.5 amps, single phase, 60 Hz, 900-watts
  • SBS: 120 volts AC, 7.5 amps, single phase, 60 Hz, 900-watts
  • CSB1: 120 volts AC, 7.5 amps, single phase, 60 Hz, 900-watts
  • CSB2: 120 volts AC, 7.5 amps, single phase, 60 Hz, 900-watts
  • BTX: 120 volts AC, 7 amps, single phase, 60 Hz, 850-watts
  • CSB3T: 120 volts AC, 7 amps, single phase, 60 Hz, 850-watts

FEATURES

BUNN 55200 CSB3T Speed Brew Coffee Maker 1

  1. Brew Funnel
  2. Lid
  3. Internal Hot Water Tank
  4. Drip-Free Glass Carafe
  5. Carafe Lid
  6. Warmer Plate
  7. Sprayhead
  8. Warmer Switch
  9. Tank Power Switch
  10. Pour-In Bowl
  11. Thermal Carafe
  12. Thermal Carafe Lid
  13. Base
  14. Top Cover

SAFEGUARDING

IMPORTANT
Follow basic safety precautions when using electrical appliances to reduce the risk of fire, electric shock, and personal injury.

  • READ ALL THE INSTRUCTIONS IN THIS MANUAL.
  • Use caution. This coffee maker produces hot liquids: hot liquids can burn you
  • Place and use the coffee maker on a level surface.
  • Do not touch hot surfaces. Use handles.
  • Do not tip the coffee maker.
  • To protect against electric shock, do not place cords, plugs, or coffee maker in water or other liquids.
  • Close supervision is necessary when a coffee maker is used around children.
  • The internal hot water tank contains hot water. Before removing or replacing parts, press the power switch off, unplug the coffee maker, and let it cool (up to 2 hours.)
  • Do not operate the coffee maker with a damaged cord or plug, or any other malfunction or damage. Using an accessory not evaluated for use with this coffee maker may cause injury
  • Use a coffee maker indoors only.
  • Do not let the cord hang over the edge of the table or counter.
  • Do not place the coffee maker in or near a hot gas or electric burner, in a heated oven, or in any other heated area.
  • Do not use a carafe on a range top or in a microwave.
  • Do not use the coffee maker for any purpose other than its intended use.
  • Do not remove the brew funnel or carafe while brewing.
  • Do not set a hot carafe on a cold surface.
  • Do not use a cracked carafe or a carafe with a loose or weakened handle.
  • Do not pour any liquid into the internal hot water tank other than water or vinegar for cleaning, as specified in this manual.
  • Do not clean the carafe with cleansers, steel wool pads, or other abrasive materials.
  • When the coffee maker is not in use, keep the lid in the closed position.
  • To disconnect, turn any control to the OFF position to and on, the the unplug wall outlet.

INITIAL SETUP

  1. Slide empty brew funnel into funnel rails.BUNN 55200 CSB3T Speed Brew Coffee Maker 2
  2. Fill the carafe with water. Pour Water into the coffee maker.BUNN 55200 CSB3T Speed Brew Coffee Maker 3
    NOTE:
    Keep the lid open.
  3. Place the carafe under the funnel. Close lid. Wait 4 minutes while the internal tank partially fills.BUNN 55200 CSB3T Speed Brew Coffee Maker 4
  4. Repeat steps 2 and 3, until water flows from the funnel.BUNN 55200 CSB3T Speed Brew Coffee Maker 5
  5. Plug in the coffee maker.BUNN 55200 CSB3T Speed Brew Coffee Maker 6
  6. Press the power switch located on the side. (I=ON, O=OFF) Wait 15 minutes for water in the tank to heat.BUNN 55200 CSB3T Speed Brew Coffee Maker 7

HOW TO BREW

  1. Place a BUNN®
  2. coffee filter into the brew funnel
  3. Scoop ground coffee into the filter
  4. Gently shake the brew funnel to level the grounds
  5. Slide the funnel into the funnel rails
  6. Fill the carafe with water: 20oz for 4 cups, 50oz for 10 cups.
  7. Open the lid, and pour water into the coffee maker
  8. Position the carafe on the warmer plate (or on the base for Thermal models*)
  9. Close the lid**
  10. Flip the warmer switch to ON for a glass carafe brewer.
  11. Wait 4 minutes for the drip-out to complete

BREWING CHART 

BUNN 55200 CSB3T Speed Brew Coffee Maker 8

BASIC CLEANING

FOR SPEED BREW MODELS:
(Excluding Thermal models)

  • Wash the brew funnel and glass carafe after each use.
  • Both are top-rack dishwasher safe.

Important:
Separate the carafe lid from the carafe when washing in the dishwasher, and use the top shelf only for both the glass and the lid. If washing by hand, use a mild, non-abrasive dish soap.

  • Wipe the outside of the coffee maker occasionally, including the area above the brew funnel.

NOTE:
After wiping down, ensure that the warmer switch is in the OFF position.

  • To remove coffee stains from inside the thermal carafe, place a paper filter in the brew funnel and pour 2 teaspoons of powder dishwasher detergent into the brew funnel.
  • Pour one carafe of water into the coffee maker.
  • Place the carafe under the funnel and close the lid.
  • When the brewing cycle stops, remove the brew funnel and discard the filter.
  • Rinse the funnel.
  • Allow the carafe to sit for about 15 minutes.
  • Use a soft-bristled brush to clean the inside and outer rim of the carafe.
  • Scrub the carafe and pour the lip and lid with a soft cloth, warm water, and mild detergent.
  • When finished, pour out the solution in the carafe.
  • Rinse the carafe and the lid.

CLEANING THE SPRAYHEAD

Cleaning the sprayhead tube removes deposits formed by natural mineral content in your water. The more mineral content in your water, the more you should clean. A good rule of thumb is to clean the sprayhead every 3 months. If you have tough water, then twice a month may be necessary.

You will need:
a toothpick, dish soap, and a soft cloth.

Press the tank power switch to the OFF position, unplug the coffee maker, and allow it to cool for at least 30 minutes.
NOTE:
Water in the reservoir may still be hot. Do not tip  the machine

  • Remove the funnel and unscrew the sprayhead, loosening it with your fingertips.
  • Check the sprayhead holes and clear any deposits  with the toothpick
  • Clean the sprayhead with a cloth and dish soap. Rinse with water.
  • Reinstall the sprayhead.
  • Reinsert the brew funnel.
  • Plug in the coffee maker. Press the tank power switch to the ON position.
  • Wait 15 minutes for the water in the tank to reach brew temperature.
  • Your machine is again ready for brewing.

NOTE:
Cleaning the sprayhead tube with a deliming tool removes deposits formed by natural mineral content in your water. The more mineral content in your water, the more you should clean. A good rule of thumb is to clean the machine, the head,t,ube, and spray every 3 months. If you have tough water, then twice a month may be necessary if the brew time slows. See the Troubleshooting section if brew time is too slow.
NOTE:
For a replacement spray header deliming tool, call customer service at 1-800-352-2866 (USA) or 1-800-263-2256 (Canada).

TO DRAIN: 

  1. Flip the tank switch to the OFF position, unplug the coffee maker, and allow it to cool for at least 2 hours.
  2. Remove the funnel and the spray head, loosening with your fingertips.
  3. Grasp the back of the coffee maker and turn it upside down over a sink.
  4. Continue tipping the coffee maker until the flow from the sprayhead tube and lid stops.
  5. Attach the sprayhead and insert the funnel into the coffee maker.
  6. Return the coffee maker to the upright position.

TROUBLESHOOTING

BUNN 55200 CSB3T Speed Brew Coffee Maker 9

BUNN 55200 CSB3T Speed Brew Coffee Maker 10

BUNN 55200 CSB3T Speed Brew Coffee Maker 11

FOR MORE MANUALS BY BUNN, VISIT MANUALSDOCK

Leave a Comment